Netduino home hardware projects downloads community

Jump to content

The Netduino forums have been replaced by new forums at This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.


Member Since 23 Feb 2014
Offline Last Active Aug 17 2014 07:04 PM

Posts I've Made

In Topic: 1-Wire DS18B20 Programming Errors

29 April 2014 - 01:06 PM



Been able to solve the first error (Error 1). I was missing 

private OneWire _oneWire = null;


However, still i am getting error 2. :(

In Topic: New Netduino Plus 2 can not Erase or Deploy

20 March 2014 - 08:08 AM



I google through for NetDuinoUpdate. I have been able to locate Chris post (below). but i couldnt locate NetDuinoUpdate.exe on this link.




Though, in the mean time i was able to address "Error:No Response  from device" . by hit and trial  :). However, not been able to locate NetDuinoUpdate.exe :( 




In Topic: Netduino Plus 2 board always appear in TinyBooter Mode!

01 March 2014 - 12:06 PM

Hi escallanio, Can you try to upgrade your board to the new 4.3.1 firmware using "Netduino Update"? http://forums.netdui...-firmware-v431/ You may need to push the button firmly when you power it up (i.e. when you plug it into your PC via USB). Also...make sure that nothing else is attached to the Netduino when you reflash it. Welcome to the Netduino community, Chris

Hi Chris
Thank you for your reply. I tried to upgrade to the new 4.3.1 firmware, but was not successful. The reason is that, it is not booting in DFU Tester in order to erase the existing firmware. I tried many times by pushing the button firmly when i power it up but still it does not appear in DFU. Alternatively, I tried to upgrade it (without erasing existing firmware) to the latest firmware 4.3.1 via Dfuse Demo, however when i attach the latest firmware in the "Upgrade or verify Action" section, the firmware is attached, but upgrade option get disabled.
In .NETMF, when i ping it, it is automatically in bootloader form. When i firmly push the button while plugging it via USB, then the device does not appear in USB section of .NETMF.  Irrespective of pressing the pushbutton while plugging to laptop, it always appear in Tinybooter mode and never goes to Tinyclr. (I tried to upgrade my second board, it was successfully upgrade to the latest 4.3.1 as it gives Tinyclr when i ping it.). Perhaps there might be problem with the board?



home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.