Hi Guys, I'm currently just trying to get a stepper motor to simply spin, but can't seem to get any movement but there is a lot of holding torque so I know there is power going to the motor.
How its wired:
12v power supply going to the Easy Driver (m+/gnd)
gnd/step/dir on Easy Driver all going to pins in the netduino.
4 cables from bipolar motor going to Easy Driver
I also connected the 3/5v pads so the netduino can control it with 3.3V signals.
The code:
OutputPort directionPort = new OutputPort(Pins.GPIO_PIN_D5, false);
OutputPort stepPort = new OutputPort(Pins.GPIO_PIN_D6, false);
directionPort.Write(true);
while (true)
{
stepPort.Write(false);
stepPort.Write(true);
Thread.Sleep(1);
}
I'm not sure if I'm missing any connections?
Thanks,
Vikram