weixiongmei

Hi everyone, i'm porting the .Net MF to a cortex-m0 microntroller, and it can runs on the STM32F091CC now, but there's still one problem, in the Interlocked.s, couple opcodes are not supported on the Cortex-M0 core, such as LDREX, STREX, CLREX...... So is it still possible to port the .net MF to the cortex-m0 microcontroller completely? Can anyone give me some helps? Thank you~~~

Hi everyone, the .Net Micro Framework has been ported to the 256K MCUs for more fields of use, it could runs on GD32F103RCT6/STM32F103RCT6, and have been fully tested on those two MCU. All features that supported on Netduino Plus 2 are supported on this firmware, except FAT32 & lwip, but it supports some extra features that are not supported on Netduino, such as on chip CRC unit, Systick, RTC, and CAN bus.

(Note: Firmware version 4.3.1, Visual Studio debugging & deployment supported)

 We're also porting the .Net Micro Framework to a 128K MCU, of course for this tiny size, some features must be removed, such as USB client, v.FPU(Decimal Point), however, it's good for super low cost projects, GPIO, I2C, SPI, and USART are enough for most of the low cost projects.

I'll upload the firmware & pictures in about 3 days, if you're interesting in this, please check this thread few days later. This firmware is free of charge, and would be open source when we're ready.

If you have any question, please post in this thread or contact me at weixiongmei@outlook.com