Frank

Having received my NP+ today, I've now got the IP connectivity working for starters. Tomorrow's job will be to get 1 wire working. I've had lots of success in the past with the HA7S adapter ( http://www.embeddedd...r-SIP_p_23.html ) so that's what I'll be working with. I'm only going to be working with DS18B20 temperature sensors so that's all my code's going to support but I'll post it as soon as I've got it working.

Phil

How'd this work out for you ?

I also get this.

If it is the router, how do I proceed?
EDIT: Initial test without the router failed as well.

My router problem was based on sheer ignorance, followed by uninformed tweaking! I solved a multitude of home problems when I did a lot of reading, and eliminated my tweaking. If you failed without the router, one of the many real experts will surely help you. This board has good depth in experience.

If you configure as static IP and can't ping it anymore, then that's a more general network-related issue (i.e. the router doesn't support static IP clients or there's an address conflict or the gateway/subnet mask are wrong, etc.)

Go back to where you can ping your device, and try running Microsoft's SocketClient sample. That should download a page from the Microsoft website.

Chris

I wholeheartedly agree. I just spent too much time chasing my tail, and it was nothing with the NEtduino or the programming, just a router issue ! And my key was when I couldn't ping the board!

I have had very good luck with this unit: http://www.phanderso...mp/onewire.html

I agree ! Mine works well, and the price is hard to beat.