zee

Hi,

Need help here!

What's the problem here?   

Connected to 10K Ohm & PullUp.. But it keep prompts me this error.

Oh. Thanx Hanzibal. Will try to work it out. 

Hi,

Thank for the quick response. You mean, touch shield can't be used for password? In order for me to use a servo to do some actions, I need to use something like this?

 http://www.karlssonr...CFVSVMgodv04AEw

or

https://www.sparkfun.../products/10250

I'm sorry for this noob question. But, what else can touch shield do?

Problem solved !       

One of the jumper is faulty. HAHA!

I don't fully understand what you mean by "from shield board TX to resistor (with SDA) to D2" though?

 Ignore this. Haha!

I did found the solution Last Friday and when i want to try again today, seems like its not working. Whats happening??   

This should be correct right?

readonly InterruptPort irqpin = new InterruptPort(Pins.GPIO_PIN_D2, true, ResistorModes.PullUp, Port.InterruptMode.InterruptEdgeLow);

Both resistors are connectec to 5V. 1 resistor will wired up to SDA and the other resistor to SCL. And, InterruptPort is directly connected from touch shield to D2. Right?