Netduino home hardware projects downloads community

Jump to content

The Netduino forums have been replaced by new forums at This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.


Member Since 01 Feb 2013
Offline Last Active Jan 02 2015 04:21 AM

#56885 I2C Bus Problem - Debugging

Posted by yogotie on 18 March 2014 - 01:47 AM



My original fix is only applied to when the device is initialized.  It looks like your problem is occurring at some time later during a transaction.


If you are able to get a debugger, cost is $21.25 at mouser, you can check to see if the busy bit is set when the bus locks up.  If that is true then you will need to create a more sophisticated way of reseting the I2C module make this work.  You maybe able to hack something in at the start or stop call and have something spin on the busy bit and cause a reset if it takes too long.


If you do get the debugger and find this is the case I'm sure that would be interesting to Chris as well.

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.