Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Nym

Member Since 23 Jan 2013
Offline Last Active Apr 07 2013 03:25 PM
-----

Posts I've Made

In Topic: Netduino crystal Oscillator

04 April 2013 - 06:53 PM

Got it.already ordered them and running up :). Thanks


In Topic: Is possible to use Com1 for debugging and communication?

04 April 2013 - 06:50 PM

How can I do so? Sorry for asking so many questions... I have oscilloscope here only I need some guidance to test the TTL cable and what values I should be seen to know that is correct?

 

Also I'm using https://www.sparkfun.com/products/9717 . Any one other FTDI cable or board that could be better and used by other members. I know that my FTDI is able to debug/deploy and communicate because I have tested on my Netduino gen 1 board but never used sam-ba there since I connect my board using micro-usb port.


In Topic: Flashing 4.2 failed

04 April 2013 - 06:46 PM

Clear as water...Since I'm not using RS-232 level converter,my TTL should work. I'm using this cable from Sparkfun https://www.sparkfun.com/products/9717

 

I cannot get samba to work with, so I think that it doesn't like that specific cable,any other options that someone might be used?


In Topic: Is possible to use Com1 for debugging and communication?

04 April 2013 - 06:15 PM

Also nooms helped me out and we check reset,erase pins were correctly implemented.Crystal is rsponding 18.48MHz in the oscilloscope,so chip apparently is working.Let me the samba thing


In Topic: Is possible to use Com1 for debugging and communication?

04 April 2013 - 05:23 PM

yea I have erased chip about 30 times, I have found different steps about how to do so but essentially I'm doing steps recommended on mini link you posted and still no luck....Is there anything missing on the way that I'm connected my UART ports to micro?

 

Sam-ba always return "No valid processor ID found"


home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.