Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

gajtguy

Member Since 31 Dec 2012
Offline Last Active Dec 15 2013 01:57 AM
-----

Posts I've Made

In Topic: No valid processor ID found at91sam7x512

01 January 2013 - 01:32 AM

Glad to know it's not just me. Looks like we are doing the same steps and getting the same results.  I am 100% new to this whole thing and not off to a good start.

 

TinyP - If you get this going,, please provide an update

 

 

My Update - After going through the steps again with a little more focus, I got this to work. Not sure if this helps you, but I was erasing the board improperly (I guess). Holding the 3v3 pin on the erase pad 'while powering up' seemed to get me on a better path. Now I got the Blinky program to work and I'm ready for the next challenge. 

 

Tiny - Did you read the part about removing the old 4.1 drivers before using the 4.2?


home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.