EricO - Viewing Profile: Posts - Netduino Forums
   
Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

EricO

Member Since 22 Dec 2012
Offline Last Active Feb 22 2014 07:53 AM
-----

Posts I've Made

In Topic: Unable to communicate with Mini

18 February 2014 - 03:25 AM

I discovered the (or source of) problem.  Looks like the usb power was insufficient.  I left the usb cable attached and plugged in a 5V power source, voilà, communication established.


In Topic: Parallax - Ultrasonic Distance Sensor does not work

18 October 2013 - 08:06 PM

I tried your code, but no success.  Now it looks like my NP2 is bricked anyway so I guess won't  be going any further with it.

 

Thank you again for your assistance.


In Topic: Parallax - Ultrasonic Distance Sensor does not work

17 October 2013 - 05:16 PM

Thank you for the reply.  Yes, it is the Parallax Ping))). I suspect you're write about the port settings, looking at my Arduino code, which does work, I notice they handle the port quite a bit differently than the code I was using.  At any rate, I'll give your code a try and let you know.

 

Thank you again.


In Topic: SDK documentation for the Netduino SDK

25 September 2013 - 02:19 AM

Same here.  It's a little hard to know what's available.


In Topic: NP2 reboots on deploy; never debugs/runs app

11 March 2013 - 10:47 PM

I was able to get past the 'target is not in an initialized state...." problem when using 4.2 and VS2010 by upgrading to VS2012 and using 4.3 of the MF and sdk.


home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.