2xPa

Hello all,

For a prototype i work, or rather i attempt to work, i need to connect two devices over I2C (9-axis sensor and RTC clock, to be precise), and thus i wonder is it possible to use .NETMF I2CDevice while working with Netduino Go! by connecting to I2C2 pins on Go!Socket1 and Go!Socket8?

If no chances to get that to work what would be the best way to go? If developing separate module, personally i find it a huge overdo, what would be the best place to start? So far i found few resources:
- http://forums.netdui...sing-the-stm8s/ but that's for go!bus 1.0, will that code work on 1.5 as well?
- what would be best hardware start point:

• VariableLabs ProtoModule?
• STM8 or STM32 Discovery board?
• other?

is there any complete jumpstart guide to module development, as so far i've seen it scattered over web?
Just to mention, I'm .Net software developer, without prior experience with micros.

Regards and thanks in advance for tips and answers
Paweł