- Netduino Forums
- → Viewing Profile: Posts: Marius
The Netduino forums have been replaced by new forums at community.wildernesslabs.co.
This site has been preserved for archival purposes only
and the ability to make new accounts or posts has been turned off.
Community Stats
- Group Members
- Active Posts 59
- Profile Views 5975
- Member Title Advanced Member
- Age 65 years old
- Birthday January 30, 1959
-
Gender
Male
-
Location
Centurion RSA
1
Neutral
User Tools
Friends
Marius hasn't added any friends yet.
Posts I've Made
In Topic: Easydriver stepper driver class
09 October 2012 - 06:36 PM
Raj,
It does not work that way. The motor is rated at 5v continues but you are stepping it so it can handle up to 80v in some cases. Just put the 35v that the drivers can handle on that same motor and you will have the speed.
To clarify a bit. The stepper drives makes use of a PWM method of driving the coils of the motor. The PWM is modulated with a sine wave that is rotated or phase shifted as you step the drive. This phase shifting causes the motor to turn. The more micro steps you use the smoother the rotation.
Hope this makes some sense to you
In Topic: Easydriver stepper driver class
09 October 2012 - 06:59 AM
Raj
The micro step settings will influence the speed but more important is the Motor Voltage.
The higher the voltage the more speed you will get. Also if you use steppers with a high coil inductance, the speed will be lower. Th motor will alias much quicker under high step rates.
So to summarize:
Use motors with low inductance
Use the highest possible motor voltage that the driver can handle.
Look at your micro stepping settings.
- Netduino Forums
- → Viewing Profile: Posts: Marius
- Privacy Policy