Netduino home hardware projects downloads community

Jump to content

  2. → Viewing Profile: Topics: tobsen

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

tobsen

Member Since 24 Sep 2010
Offline Last Active Dec 21 2012 12:58 PM
-----

Topics I've Started

Fast mode I²C-bus with netduino?

01 December 2010 - 04:16 PM

First of all, I am completely new to this hardware related stuff so please bare with me. I would like to use the netduino to communicate with a device which uses a "1 MHz Fast-mode Plus (fm+) I²C-bus interface". I read "Fm+ devices offer higher frequency (up to 1 MHz)" but I am not sure if this is supported by the netduino "two wire interface" (which I assume is the equivalent of the I²C interface?) or if the "fm+ interface" is backwards compatible. Any info on this is appreciated, thanks in advance.

  1. Netduino Forums
  2. → Viewing Profile: Topics: tobsen
  3. Privacy Policy
home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.