- Netduino Forums
- → Viewing Profile: Topics: awaiK
The Netduino forums have been replaced by new forums at community.wildernesslabs.co.
This site has been preserved for archival purposes only
and the ability to make new accounts or posts has been turned off.
Community Stats
- Group Members
- Active Posts 90
- Profile Views 15000
- Member Title Advanced Member
- Age Age Unknown
- Birthday Birthday Unknown
-
Gender
Not Telling
4
Neutral
User Tools
Friends
awaiK hasn't added any friends yet.
Topics I've Started
Powering from 5V power supply
03 October 2012 - 07:24 PM
Hi,
I'm affraid it is not possible, but...: Can I power a netduino mini from a 5V power supply, directly? (Without using additional components like a DC-DC converter)
COM1 voltage level
22 September 2012 - 03:05 PM
Hi,
it seems to me the netduino mini COM1 port (pin 11-12) use 5V for TTL signals.
But it should use 3.3V, right?
Since I'm not that hardware-expert, would be really nice if somebody can check his netduino mini COM1 port, which voltage level is used.
UART data flow control on netduino Mini
20 September 2012 - 01:16 PM
Hi,
am I correct that, there are no dedicated CTS/RTS pins to enable hardware-based data flow control?
So, I have to implement data flow control by myself using two GPIOs?
netduino article in dotnetpro magazine
16 July 2012 - 11:43 AM
Today I noticed the german dotnetpro magazine has written an article about netduino and the .NET Micro Framework.
It's the second .NET MF related article I noticed in the past few days in german magazine. Nice to see .NET MF gets some editor's attention. Did anyone see other articles in the past few weeks?
- Netduino Forums
- → Viewing Profile: Topics: awaiK
- Privacy Policy