Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Jon Henry

Member Since 27 Feb 2011
Offline Last Active May 13 2013 11:15 PM

Find content

Received

#47576 Netduino Plus 2 Firmware v4.2.2 (update 2)

Posted by Jon Henry on 25 March 2013 - 10:50 PM

So, I tried again before sending it back. I flashed to 4.3, didnt work. Flashed back to 4.2.2 and still doesnt work.

DfuSe demonstrator says the 4.2.2.dfu firmware is onboard, confirmed with MFDeploy.

Heres the problem.

I disconnect and reconnect the cable and try writing my program to the N+2. Correct framework and target device selected. NetduinoPlus2_Netduino is showing. Get an error, unable to communicate with device USB:Netduino. Disconnecting and reconnecting doesnt work.

I have a N1 which works perfectly, same program runs on it solid.

After trying to write from VS2012, I go back to MFDeploy, NetduinoPlus2_Netduino shows up but when i go Target>Device Capabilities I just get a Not Supported in the memo box.

Any insight?