Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Coyttl

Member Since 30 Jul 2012
Offline Last Active Mar 14 2017 06:51 PM
-----

#65463 Data Scan rate..

Posted by Coyttl on 02 August 2016 - 12:02 PM

This may be a silly question, but not knowing the proper/exact terminology to reference, added to the overhead of the .NET Micro Framework, I figured I'd ask here and get some input -

 

If I had a data bus running at 1Mhz (high -> low 1 every ms), would the Netduino 3 (hell, or 2 for that matter!) be able to scan Digital inputs fast enough to not lose any state changes?

 

I know the chip runs at a higher speed, but wasn't sure how much of that was put towards scanning ins/outs and put towards basic running of the MF.

 

Cheers -

Mike




home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.