Here's a project that uses a Netduino-based motion sensor to trigger video captures on a Windows 8.1 tablet or laptop (http://channel9.msdn...D-motion-sensor)
- Netduino Forums
- → Viewing Profile: Topics: donnmo
Community Stats
- Group Members
- Active Posts 28
- Profile Views 10101
- Member Title Member
- Age Age Unknown
- Birthday Birthday Unknown
-
Gender
Male
-
Location
Spokane area
User Tools
Friends
donnmo hasn't added any friends yet.
Topics I've Started
Netduino-based motion sensor that triggers video captures
28 January 2014 - 05:33 PM
RS232 deployment works with Netduino Plus but not Netduino
04 December 2013 - 06:30 PM
Hello,
I've installed the 4.1.1.0 beta firmware on a Netduino board and tested with a simple app to ensure that it's working. (Blinking LED...)
Next step was to add an RS232 shield and test HID firmware that's already running on a Netduino Plus. I attached the shield and used a USB/RS232 cable [with FTDI chipset] to deploy the firmware. However, the deploy fails and times out. The error I see is: "Unable to communicate with device - Serial: COM4".
Just to verify that there wasn't an issue with the shield or cable, I reattached the same shield to a Netduino Plus and deployed. This worked without any issue.
Has anyone else observed similar issues with RS232 shields and the Netduino?
Thanks!
--Donn Morse
fluctuating LM35 values
29 October 2013 - 10:15 PM
I've attached an LM35 to both a Netduino and a Netduino Plus. The readings fluctuate unexpectedly on both boards.
The attached screenshot shows three columns of data: The first is the value retrieved from the AnalogInput.Reading method; the second is the temperature in degrees Celsius; the third is the temperature in degrees Fahrenheit.
These readings were taken when the LM35 was sitting on my desk in a room that's showing 75 degrees Fahrenheit on a digital thermometer in the same room. (The readings are within an acceptable range--but--I don't understand the fluctuations.)
Has anyone else observed this with the LM35?
Thanks!
--Donn
Netduino-based motion-sensor for Windows 8.1
20 September 2013 - 07:23 PM
Microsoft released an end-to-end sample for Windows 8.1 that uses a Netduino-based motion sensor. The sample Windows app (included as part of the solution) triggers 5 seconds of video-capture when the motion-sensor detects movement. Here's a link: http://code.msdn.mic...sensor-39bea694
- Netduino Forums
- → Viewing Profile: Topics: donnmo
- Privacy Policy