EddieGarmon

Add a simple RC circuit or ladder to the output of a PWM signal. The RC will level the voltage and will set the parameters for the quickness it responds to input change.

If you want a working implementation of Tasks today for MF 4.2 and 4.3 I have them up on NuGet here:

https://www.nuget.or...ober.Threading/

Amperage rating of the DC source will need to be at or above the total needs of your system, so yes, unfortunately, it does depend.

Tall plastic tube is a nylon spacer .5 in long, .188 in outer diameter, 0.117 in inner diameter, bought from a local True Value Hardware store.

I also have 3 @ 0.25 in OD, 0.115 ID underneath.

I believe the hole position is an artifact of arduino design before I2C had independent pins near there.

for play, this is all you need...