deashute

Hi all,

I am a relative beginner when it comes to Netduino programming. I am attempting to use an Adafruit Motor Shield v2 with my Netduino Plus 2 to control two stepper motors. I've done a bit of research into the I2C protocol, but find myself somewhat confused about it's implementation, and how I can directly use it to control the steppers. Does anyone out there think they can help me to understand I2C's implementation?

Thanks,

Dean

I suppose I should also mention that I have, in searching the forums, found many an example of how to initialize an I2C device, however I am unsure of how to directly communicate with said device once initialized.

I'm going to try to bring this thread up to the front, as I have the same question as David. I have also reviewed several different code samples for the original, and have not found a single usable one for v2.