Is there a way to choose what loads depending on the device being deployed to? I use both the ND2Plus and the ND3Wi-Fi
If I deploy to a ND2Plus I get the following crash during debug:
Assembly: SecretLabs.NETMF.Hardware (4.3.1.0) Resolving. Link failure: some assembly references cannot be resolved!! Assembly: NetduinoExtensions (4.3.2.1) needs assembly 'Netduino.IP' (1.0.0.0) Error: a3000000 Waiting for debug commands... The program '[36] Micro Framework application: Managed' has exited with code 0 (0x0).
I had the same problem when I tryed to use ND2+ with the program used on ND3.
You must update the Firmware of the Netduino 2 with the 'Netduino.IP':
http://forums.netdui...etduino-plus-2/
After the upgrade you should be able to run your program without problems.
- TechnoGuy likes this