Custom Netduino, how to upload .net micro framework at first time ? - General Discussion - Netduino Forums
   
Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.
Photo

Custom Netduino, how to upload .net micro framework at first time ?


  • Please log in to reply
2 replies to this topic

#1 xmen

xmen

    Advanced Member

  • Members
  • PipPipPip
  • 72 posts

Posted 06 June 2016 - 02:59 AM

I have a custom netduino 2 and I want to upload .net micro framework. But when I plug the USB, there is no notification in windows which shows a new hardware is attached, is this normal ? and how should i upload the .net micro framework, I know how to update it but what happens at very first time on a clean STM32F205 ?



#2 Frode

Frode

    Advanced Member

  • Members
  • PipPipPip
  • 202 posts
  • LocationNorway

Posted 01 July 2016 - 06:55 AM

Should be the same. Are you sure you've soldered the board correctly?



#3 xmen

xmen

    Advanced Member

  • Members
  • PipPipPip
  • 72 posts

Posted 08 July 2016 - 11:16 AM

Oh I soldered like 10 uCs, checked wiring many times. Only problems I found was the crystal was too far, like trace length was 43mm and other one was 25mm approx. I moved crystal very close and now using 4 pin crystal instead of 2. And now its working fine.






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.