I have a custom netduino 2 and I want to upload .net micro framework. But when I plug the USB, there is no notification in windows which shows a new hardware is attached, is this normal ? and how should i upload the .net micro framework, I know how to update it but what happens at very first time on a clean STM32F205 ?
Custom Netduino, how to upload .net micro framework at first time ?
Started by
xmen
, Jun 06 2016 02:59 AM
2 replies to this topic
#2
Frode
-
- Members
-
- 202 posts
Advanced Member
- LocationNorway
Posted 01 July 2016 - 06:55 AM
Should be the same. Are you sure you've soldered the board correctly?
#3
xmen
-
- Members
-
- 72 posts
Advanced Member
Posted 08 July 2016 - 11:16 AM
Oh I soldered like 10 uCs, checked wiring many times. Only problems I found was the crystal was too far, like trace length was 43mm and other one was 25mm approx. I moved crystal very close and now using 4 pin crystal instead of 2. And now its working fine.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users
