I'm trying to run my first program on a Netduino Go bought a few days
My platform is Win7 Professional / 32 bit, and I'm using Visual Studio C # 2012 Express.
When I connect to the computer turns on NetduinoGo 1 led white and 8 blue leds.
Then, after a 2 seconds, all together it off and stay off even though they are connected to an LED, a potenzimetro and a button.
Also carry the following guess with the errors that appear in Visual Studio C # 2012 Express.
I also tried restarting my PC as an integrity check. The Netduino is listed in Device Manager and the Deployment Tool also seen.
I show you some screenshots of my C#
Do you have ideas?
Do you think my NetduinoGo is dead?
NetduinoGo and strange behavior
Posted 07 August 2014 - 04:23 PM
Posted 08 August 2014 - 08:13 PM
Your SDK is currently targeting 4.3 firmware, instead of the 4.2 firmware used on your board. If you open up the Project Properties and change target framework to ".NET Micro Framework 4.2"...does that get you up and going?
Welcome to the Netduino community,
Posted 14 August 2014 - 01:40 PM
Thank you for your answers, your confidence in the product Netduino made ??me look better where could be the error and finally I found it, now everything is working properly and the examples that I've tried have given me great satisfaction.
There is only one thing that I can not run properly is "ShieldBase."
Since 'I wanted to connect analog sensors that have already' bought, I connected "ShieldBase" to NerduinoGo.
But just plug it in with the flat cable and the program gives me error and all the LEDs are off, by any chance I have to update the firmware "ShieldBase"?
Posted 14 August 2014 - 02:14 PM
a big thank you ... I take it immediately
Posted 14 August 2014 - 03:26 PM
I downloaded the update firmaware indicated at the link
and I followed the steps indcati by Chris
but here's what I get when I run the program STM32ReflashApp
What can I do?
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users