I do, but they are all Windows 8, x64. I suppose it could be the USB ports though. I tried a second Netduino that I have and it looks ok, so it's not the USB cable anyway.
Arian's Content
There have been 5 items by Arian (Search limited from 27-April 23)
#44919 Is my Netduino fried?
Posted by
on 04 February 2013 - 08:10 PM
in
Netduino 2 (and Netduino 1)
#44911 Is my Netduino fried?
Posted by
on 04 February 2013 - 07:21 PM
in
Netduino 2 (and Netduino 1)
Hi Arian, If the device appears as "GPS Camera Detect" when you plug it in, it's likely fine. That means that it's booting into the Atmel SAM-BA bootloader. Are you running the latest SAM-BA (2.12 with patches)? If so, I would also try "uninstall driver and remove it from my computer" on the "GPS Camera Detect" device. Chris
I had to manually assign it the GPS Camera Detect driver (based on other forum posts). When I uninstall and delete drivers, then plug it back in again, I go back to unknown device. I can download and install the GPS Camera Detect drivers again, but the device still won't start.
#44907 Is my Netduino fried?
Posted by
on 04 February 2013 - 07:02 PM
in
Netduino 2 (and Netduino 1)
I had troubles with updating my Netduino on Windows 8 x64 and ended up shorting the gold dot and 3v to reflash the firmware. I can't seem to do anything with it now. When I plug it in with the reset switch down, then select the GPS Camera Detect driver, it installs but says that the device can't start (code 10). Of course from there I can't do anything else. Is there anything else I can try to even get it a COM port to update with Sam-ba or is that enough info to indicate that it's fried?
I should also point out that this is on multiple USB ports, and not through a USB hub. Also, I find it interesting that Device Manager shows the hardware ID as USBDEVICE_DESCRIPTOR_FAILURE. Maybe that's normal before the driver is installed though...
#39378 Netduino 1 Firmware v4.2.0 (update 1)
Posted by
on 14 November 2012 - 08:42 PM
in
Netduino 2 (and Netduino 1)
Are you running the latest version of SAM-BA (2.12+)?
Have you tried rebooting your PC, unplugging and reattaching the board, and then running SAM-BA again?
Yes to all of the above.
#39324 Netduino 1 Firmware v4.2.0 (update 1)
Posted by
on 14 November 2012 - 06:06 AM
in
Netduino 2 (and Netduino 1)
I'm about ready to give up. I'm trying to update the firmware and I'm not having any luck with the Tinybootloader upgrade. I bridged the gold dot and 3v, and I can get a GPS Camera Detect serial port (image0.png), but when I point Sam-ba to it, it accepts the port and chip type (image1.png), then simply disappears. If I try to run it again, I get a message indicating it's still running (image2.png), but I never see it again! What do I need to do?
