Netduino home hardware projects downloads community

Jump to content

The Netduino forums have been replaced by new forums at This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Member Since 12 Feb 2013
Offline Last Active May 05 2013 03:09 AM

Posts I've Made

In Topic: Netduino Plus 2 Firmware v4.2.2 (update 2)

20 February 2013 - 07:01 PM


I have installed a few programs onto a netduino plus and now I have moved to a netduino plus 2 for more memory.


I have loaded my original code and debugged it a couple times, but now I can't get a response. it does not appear that the PC usb is recognizing the Netduino plus 2 is connected, so I do not get the option to select a device in the

STDFU Tester application. When I connect the netduino to the PC with the reset button pushed, It is ON (pwr LED) and the blue LED stays on....when I connect it without the reset button pushed, The blue LED start in the on state and changes to the ff'state. I assume this means that I am successfully entering the bootloader and that the unit is not entirely dead. How Do I get it to accept a download and/or accept an update of the firmware?


Thank you,


home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.