Hosein Alipourian

Hi, First of all, thank you guys for your great job on Netduino out there. I'm a new user to Netduino that do know a little about electronics. I was in middle of trying to run a stepper motor that something happened: I connected GND of my Netduino to GND of my power supply for the stepper motor. I was testing voltage between other parts on my bread board, that my Netduino restarted and from then on my PC does not recognize my Netduino, in addition to that my Netduino functioning is become slow! Boot time has been significantly increased and my last deployed project on it (That was a blinking LED which was controlled by switch) is working so slow (The frequency of the act of blinking has been decreased). It's likely that my Netduino has become dumb! What is the problem? Did I break something?! What should I do to fix the problem? By the way, sorry for my english. Thanks in advance Hosein

Hi, First of all, thank you guys for your great job on Netduino out there. I'm a new user to Netduino that do know a little about electronics. I was in middle of trying to run a stepper motor that something happened: I connected GND of my Netduino to GND of my power supply for the stepper motor. I was testing voltage between other parts on my bread board, that my Netduino restarted and from then on my PC does not recognize my Netduino, in addition to that my Netduino functioning is become slow! Boot time has been significantly increased and my last deployed project on it (That was a blinking LED which was controlled by switch) is working so slow (The frequency of the act of blinking has been decreased). It's likely that my Netduino has become dumb! What is the problem? Did I break something?! What should I do to fix the problem? By the way, sorry for my english. Thanks in advance Hosein