Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

JonnyBoats

Member Since 30 Nov 2010
Offline Last Active Aug 03 2014 04:12 PM

Find content

Topics I've Started

Flashing modules via go!bus

30 May 2012 - 03:24 AM

In another thread Chris stated: The modules should be flashable via go!bus, no special hardware required. And with the upcoming standard virtual I/O firmware, you'll be able to just say "use pins X, Y, and Z on the STM8S for the following features" and no knowledge of C or STM8S architecture will be required. Those pins/features will simply become "part" of the mainboard. WHat is the current status of this? I would like to flash a potentiometer module.

Design surface like .NET Gadgeteer for Netduino GO?

18 May 2012 - 05:09 PM

The design surface in Visual Studio for .Net Gadgeteer is very cool, particularly for documenting how the modules are connected. The code generation is of less interest to me for Netduino GO.

Here is a blog post showing how it works.

Has anyone given any thought to having this for Netduino GO?