bogdan

Hello again.

In OutputAfterDebug.txt, is the message in the Output window that shows, after I press F5 (Start Debugging)

In OutputAfterDeploy.txt is the message in the Output window that shows, after I press right-click on the project name, and click "Deploy"

Is there an incompatibility with the netduino firmware and the .net micro framework? I can't seem to figure this out

Thanks a lot !

Later edit: No, I am not running inside a virtual machine

 OutputAfterDebug.txt   4.02KB   10 downloads  OutputAfterDeploy.txt   142bytes   6 downloads

Hey Chris

I have a problem with my Netduino Plus 2. I flashed the firmware and set the mac address, exactly as you mentioned in the first post. But when I deploy an application from Visual Studio to the device, it just simply does nothing. I deployed the BlinkingLed example, nothing complicated.

Visual Studio doesn't seem to have a problem, because because it tells me that the deploy was successful.

I found in another post of yours, a way to erase my netduino app manually. The device responds when i ping it, but when i put it into pre-boot, no device is found, and i cannot erase it.

Any tips?

Thank you