Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Arian

Member Since 29 Apr 2011
Offline Last Active Feb 04 2013 08:14 PM
-----

Topics I've Started

Is my Netduino fried?

04 February 2013 - 07:02 PM

I had troubles with updating my Netduino on Windows 8 x64 and ended up shorting the gold dot and 3v to reflash the firmware.  I can't seem to do anything with it now.  When I plug it in with the reset switch down, then select the GPS Camera Detect driver, it installs but says that the device can't start (code 10).  Of course from there I can't do anything else.  Is there anything else I can try to even get it a COM port to update with Sam-ba or is that enough info to indicate that it's fried?

 

I should also point out that this is on multiple USB ports, and not through a USB hub.  Also, I find it interesting that Device Manager shows the hardware ID as USBDEVICE_DESCRIPTOR_FAILURE.  Maybe that's normal before the driver is installed though...


home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.