Elisoj

I was able to switch to serial deployment earlier following the instructions here. However, after flashing the board to v4.2.0 the enhanced MFDeploy build provided with the instructions does not recognize my netduino anymore (while the current MFDeploy 4.2.0.0 does).

I guess this has something to do with new USB drivers that were installed during the flashing process.

Is there another special build of MFDeploy that allows me to set the deployment transport?

 

Thanks a lot

Hello Netduino Community,

I am a complete noob in embedded development and electronics. I just ordered a Netduino to follow along the new Arduino tutorials. With my background as a professional .NET developer I figured it would me more appealing to me than using an Arduino.

However, I am a bit uncertain as far as controlling motors is concerned. There is the Adafruit motor shield for Arduino which isn't that simple to get to work with the Netduino from what I found in these forums. Then there is another Arduino motor shield for which someone developed a driver. I haven't tested any of these options. Can anyone comment on the idea to use the .NET gadgeteer motor module plugged into a Netduino Go? Is this a valid way to go, has anyone tried it out?

Generally speaking, are there any incompatibility issues with using Gadgeteer modules with Netduino Go? For example, will the relay and RFID module also work?

Best regards