I've been looking into porting eLua to the Netduino.
Currently eLua supports the Netduino chip (at91sam7x512) but not the board i.e. I can build and flash the firmware but the device does not seem to boot.
Diagnosing this without JTAG is going to be ... very interesting.
I was wondering if anyone here with low level board support skills would be willing to have a look into the port and report back any findings / insight?
Lua is a wonderfully easy language to teach to kids and I'd like to expand the reach and capabilities of the Netduino through this.
(after a sucessful Lua port, I'd probably look into PyMite next).
I look forward to your responses.
-(e)
EDIT:
Turns out that eLua DOES boot. I just had the incorrect serial port connected (UART2 i.e. pins D2&D3 are required, not D0 and D1).
This means that the default compile works for the Netduino, exciting stuff! I will post progress in this thread.
- swartzkb likes this