Outthereman

Hi

I have seemed to have fried my NP2.

When I plug in usb, the voltages drop over 5 v rail (no reading) and 3 v rail (2.2v).

If I unplug the usb cable and plug in an external power supply (7.5v) the readings is 5v and 3.3v respectively.

The device does not show up in the devices and printers list, nor in STDFu tester and DFuSe demonstration.

Any thing I can do or is it ready for the bin?

Thank you

Wilhelm

[font="'courier new', courier, monospace;"]Hi[/font]

[font="'courier new', courier, monospace;"]I am busy doing a project (battery management system for a 4x4) where i want to mount the netduino module on a breadboad. The reason for this is mainly vibration and i want pin connections instead of wires as far as possible.[/font]

[font="'courier new', courier, monospace;"]My problem is that i do not want to mount the Netduino module face down. (Want to be able to access the reset button, sd card etc ...) All the input and output pins facing upwards.[/font]

[font="'courier new', courier, monospace;"]Possible solutions:[/font]

[font="'courier new', courier, monospace;"]1) Unsolder the connector blocks and turn them around. (What is the risk of damaging the module?)[/font]

[font="'courier new', courier, monospace;"]2) Build a connector block next to the current blocks and link the pins with a piece of veraboard. (see attached image)[/font]

[font="'courier new', courier, monospace;"][font="georgia, serif;"]Any other suggestions?[/font][/font]

[font="'courier new', courier, monospace;"][font="georgia, serif;"]Thanks[/font][/font]

[font="'courier new', courier, monospace;"][font="georgia, serif;"]Wil[/font][/font]