Netduino home hardware projects downloads community

Jump to content

  2. → Viewing Profile: Likes: Cyclone_ZA

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Cyclone_ZA

Member Since 21 May 2012
Offline Last Active Jul 31 2015 08:13 AM
-----

#32185 74HC595 Shift Register Question

Posted by Cyclone_ZA on 18 July 2012 - 11:10 AM

Hey Guys, Just have a question regarding using 74HC595 Shift Registers... With connecting a typical 74HC595 Shift Register circuit (2 x 74HC595 IC's) to the Netduino ... what is the easiest way to get all the outputs on the 74HC595's to start LOW when the board is powered up? (Currently the pins are HIGH while the Netduino boots up, until it's fully booted) I've thought of using a relay circuit, which I will turn on via one of the DIO pins when the board is booted. Are there other options I should consider? Thanks!


#30587 Graphic LCD Driver (ITDB02-2.2SP)

Posted by Cyclone_ZA on 12 June 2012 - 12:23 PM

Hi All,

Recently bought an ITDB02-2.2SP TFT LCD (Link) for use with one of my projects.

But cant seem to get this screen to do much - anyone know of a driver for this LCD? Uses a HX8340 controller.

Any help would be appreciated!

Thanks!


  1. Netduino Forums
  2. → Viewing Profile: Likes: Cyclone_ZA
  3. Privacy Policy
home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.