Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

steenis

Member Since 01 May 2012
Offline Last Active Oct 02 2013 02:00 PM

Find content

Posts I've Made

In Topic: SPI configuration for multiple devices

10 September 2012 - 10:28 AM

This link does not show any code ...

In Topic: How do I reset Netduino Mini?

01 July 2012 - 09:44 AM

Hello Chris, Is there already an answer to the question of Omar? I am having the same problem. I cannot get a response from the mini on com1. If I apply the reset-procedure, the mini is not going into bootloader mode, and the loaded program keeps on working. The mini is not pinging on com1, even is the DTR is connected to 5V. So I do not know what to do. I have the same (3.3V) USB-to-serial connection to the PC as Omar, RX is connected to RX, TX is connected to TX. PuTTY or TeraTerm is not responding to escape, but the red led on the littel red board is flashing if I hit the escape. (I am new here.) Hugo van Steenis

steenis

Community Stats

User Tools

Friends

Posts I've Made

In Topic: SPI configuration for multiple devices

In Topic: How do I reset Netduino Mini?

steenis

Community Stats

User Tools

Friends

Posts I've Made

In Topic: SPI configuration for multiple devices

In Topic: How do I reset Netduino Mini?

Sign In