Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

T&N

Member Since 14 Apr 2012
Offline Last Active Jul 29 2012 04:21 AM
-----

Topics I've Started

Blue socket LEDs stay lit

14 April 2012 - 04:45 PM

The blue LEDs will not go off even though there are no modules plugged in. When I plug in the rgbLED module nothing changes. I've tried rebooting, other usb power sources (another computer, another cable), reflashed (the firmware),... without success. I'm using Microsoft MF 4.2. while using the MFDeploy utility, ping pruduces "TinyCLR" and device capabilities shows version 4.2.0.0. Upon inititial power up (with the rgb led plugged in), ony the white power light was lit. After unplugging and repluuging into the USB the current all blue lights situation occured. I've tried deploying the rgb led sample and get the following messages while deploying: "the debugging target is not in an initialized state; rebooting" and then "the debugging target initialized successfully" I've run out of idea's, hope someone can help. Todd

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.