Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

firestar

Member Since 09 Apr 2012
Offline Last Active Jan 26 2013 02:38 PM
-----

#42654 Smart Meter PCB

Posted by firestar on 03 January 2013 - 06:36 PM

Hi All,

 

I made my first design for a PCB using Fritzing. It will be used to read out the P1 port of my meter. I have this currently built up on my breadboard and seems to work nicely.

 

It has an EEProm for storage of settings (NTP Server, IP settings, Serial settingsetc..)

FET for signal inversion

Two LEDs for Web activity and P1 Activity

A switch to broadcast UDP messages to my AddressServer (based on BOOTP) to externally set IP parameters.

 

As I'm not an electronic designer, I'd like to get some feedback on the design. I tried to segregate the +5VDC as much to the bottom plane and the grounds to the top plane.

 

I'll make a shield out of it, but I have reduced the print to what I need in space (and drop price), that's why top left pins will not be used.

 

Thanks in advance.

 

 

Attached File  P1 Final_pcb.jpg   31.81KB   63 downloads




home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.