Netduino home hardware projects downloads community

Jump to content

  2. → Viewing Profile: Topics: Coskun

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Coskun

Member Since 16 Mar 2012
Offline Last Active Dec 06 2012 09:24 PM
-----

Topics I've Started

Baud rate problem with uLCD 32PT SGC

14 April 2012 - 01:57 AM

Hi all, Have been playing with 4D's uLCD 32PT (SGC). Everything is fine as long as I work with Baud Rate 9600. My commands work, I can work with the LCD. However, if I want to change the Baud rate (I have to start it with 9600 and then change it later on), I cannot seem to pass above 56000 (56000 itself works). If I set the BR to anything higher than 56000, Netduino Plus and the LCD cannot communicate. The screen is supposed to support up to 256000. What might I be doing wrong? Is it a limitation with the NDP? Port used: COM2 (D2, D3). Thank you in advance. BR.

  1. Netduino Forums
  2. → Viewing Profile: Topics: Coskun
  3. Privacy Policy
home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.