WriterGuy

Unfortunately, I had to unsolve my problem. Replacing all the components back into my case seems to have brought my phantom flashing LEDs back from the grave. The capacitors are in place and making good connection, its just something about having everything together inside the case is triggering the issue anyway. 

I was able to fix the problem by adding .1uF capacitors between the interrupt port pins used and ground. This seemed to stabilize the circuit and there are no random flashing lights at all! Thanks to all that helped out!

KiwiDev,

Thanks for the reply. I actually just went the Thread.Sleep route because I wasn't having luck with the timers. Would setting up a timer for each of my 6 interrupts be relatively easy or would it be adding a lot of extra code?

Every time I try to upload the diagram, I get an error saying that "no file was selected for upload." Is this a common problem on the forums?

I seem to be unable to upload any files. Any time I select my file to upload, it loads for a second and then says that "no file was selected for upload". Is this a common problem on the forum?