Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

tridy

Member Since 04 May 2015
Offline Last Active Jul 14 2017 11:35 AM
-----

#70776 netduino3 now works with VS2017

Posted by tridy on 08 July 2017 - 09:21 PM

working_driver.png

 

Yes! Now both the driver works and VS 2017 can deploy to it.

 

And I was able to create the blinking led demo from http://docs.ghielect...rials/gpio.html

 

Thanks! 

 

P.S. Since Netduino has the white power led that shows when the device is on, what do yo think about the idea of having blue led on while booting and turning it off after the boot is finished?




#64324 Flashing Netduino Mini with Netduino 3

Posted by tridy on 17 October 2015 - 07:49 PM

I read somewhere in this forum that it is better to get a "USA-19HS Keyspan USB to Serial Adapter" since it is more reliable but I don't have any experience with flashing Minis yet and if it is possible to get them bricked by unreliable USBs. It is hard to find a 19HS in Europe and I actually have a FTDI cable but I think it is 5v, so I will need to do more research. I also have one of USB to I2C IIC SPI UART TTL Converter that has 5/3.3V switch that might work. I guess I will figure it out along the way.

 

regards




home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.