backseatdriver

I have an old 68HC11EVB that I want to communicate with from my nd+2 via SPI... 

1)  What's a good way (following GEP of course) to deal with the 5V / 3V3 difference? 

2)  Is it true that the nd+2 can't operate as an SPI slave? 

3)  Anyone know of a similar project that I can reference? 

Thanks in advance.

bsd

Hello,

I want to use an Atmel AT24C08D I2C serial 8k x 8 EEPROM with my ND+2.

http://www.atmel.com...D-Datasheet.pdf

With this chip, bits 1 and 2 of the I2C device address byte are used as the two most significant bits(A9 and A8) of the memory word address.

I've searched the forum and the internet and haven't found any information on how to handle this.  Is there a way to manipulate the read only I2CDevice.Address using Reflection or some other method?

Thanks.