Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

xnorbi

Member Since 27 Sep 2014
Offline Last Active Oct 02 2014 12:24 PM
-----

Posts I've Made

In Topic: MPU 6050 Data are not constant

27 September 2014 - 12:15 AM

Hello
 
I have a similar problem with MPU6050, when I read raw gyro values from the sensor its totaly wrong. I include log file.
When the sensor is in my desk  in rest the raw data looks to be OK(after calibration). But when I move with the sensor(from line 267. int the log file) its immediatly jumps to about ~65000.
 
Also its always shows 229 degrees C.
 
In MPU6050.txt file are the setup values and functions for read, write and calibrate the sensor.
In the LOG.txt are sensor data loged with FRDM-KL25Z to microSDcard(the minimum value is -9999 and the maximum is 99999 what i can write to it).
 
Can anyone help me? Is it possible that the sensor was broken?
Attached Files
Attached File  LOG.TXT   142.65KB   0 downloads
Attached File  MPU6050.txt   16.92KB   0 downloads

home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.