Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

w3n

Member Since 17 Sep 2014
Offline Last Active Jan 07 2015 10:39 AM
-----

Posts I've Made

In Topic: Adafruit 16-channel 12-bit pwm/servo shield

01 January 2015 - 08:08 PM

Hi Iced98lx thanks by your reply!,

I was following your posts and using your driver, tomorrow I they are delivering me the non-shield version, so tomorrow I'll be back on this and see if I'm able to make it work, the funny thing is I don't understand why the shield version is not working I'm starting to suspect  somehow I burned it, because there're a few blogs about people using this same shield with a rasberry pi...


In Topic: Computer doesn't recognize plus 1

30 December 2014 - 03:00 PM

that's a normal behaviour, you 'll need SAM-BA and install a driver to emulate a COM port to be able to connect to the device, follow the steps at this guide, it worked for me -and I'm a total noob on this - so must work for you.

 

http://wiki.netduino...ep-by-step.ashx

 

Good luck!


home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.