mbrossett

Can anyone tell me if the netduino 2 has a problem using two serial ports in an application. I have each working fine on their own. However, when I tried to open both in an application I get an exception on the serialport.open() of the second one. I have tried everything. Please help!

Why does the Netduino disconnect and reconnect several times when I start a debug session? It will eventually start the debug, but up to that point Windows shows the Netduino being dettached and reattached 3, 4, 5,... times before it goes. Any ideas?

@Chris Walker and Secret Labs

 

Any chance we could see a Netduino with a powerful micro like the LPC4357? I would really like to see a Netduino with a 24-bit LCD port. Although, the hardware cost would be higher, it would be cool to see a port for the Intel Quark processors, too.

 

How difficult is it to port NETMF to a new processor?

Can someone tell me how to add STM32F4 pins (i.e. PA4, PA5, PC8, PC9, ...) to the Cpu.Pin enumeration and use these I/O? Obviously it would require physical access to these pins, for example a custom Netduino board.

 

I am guessing it would require a modification to the Netduino firmware and a rebuild. Has anyone done this?

Does anyone know the significance of having BOOT0, PB11, and PC14 tied together? I understand why BOOT0 is pulled low and has a switch, but why PB11 and PC14? Do they just need to be pulled low when unused?