Netduino home hardware projects downloads community

Jump to content


The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

NameOfTheDragon

Member Since 27 Feb 2014
Offline Last Active Feb 16 2017 07:48 PM
-----

Posts I've Made

In Topic: cncBuddy: Netduino Plus2 CNC Machine

16 February 2017 - 11:58 AM

My view on open source is that it should be done wholeheartedly or not at all. There is really no middle ground. if you publish your code then people are going to use it, and sooner or later someone will use it in a way you don't approve of. You can license all you want but this is just a fact of life, ultimately you can't control how people behave. So when I make my code open source, I do so with no strings attached. If I'm not prepared to send my code out into the world without worrying about it's destiny, then I don't open it.

 

Best regards,

Tim


home    hardware    projects    downloads    community    where to buy    contact Copyright © 2016 Wilderness Labs Inc.  |  Legal   |   CC BY-SA
This webpage is licensed under a Creative Commons Attribution-ShareAlike License.