- Netduino Forums
- → Viewing Profile: Posts: nturpin77
The Netduino forums have been replaced by new forums at community.wildernesslabs.co.
This site has been preserved for archival purposes only
and the ability to make new accounts or posts has been turned off.
Community Stats
- Group Members
- Active Posts 42
- Profile Views 6463
- Member Title Advanced Member
- Age Age Unknown
- Birthday Birthday Unknown
-
Gender
Male
-
Location
Newfoundland, Canada
0
Neutral
User Tools
Friends
nturpin77 hasn't added any friends yet.
Posts I've Made
In Topic: Netduino Firmware v4.2.0 RC4 (Netduino + Netduino Plus)
22 February 2012 - 02:02 PM
Ive ran into a problem trying to get my N+ recognized after the 4.2 update, Ive reflashed with Tiny bootloader and everything uploads successfully but when I run the MFDeploy tool afterwards and try to Ping the N+ I get no response. When I reflash with 4.1.06 i have no problems at all and everything runs great. Are there issues with early adopters of the N+? I have 3 N+ units and all do the same thing. Im using all the latest SDK that was on here for download. Ive used 3 different machines to eliminate any driver issues or USB possibilities. Im at a loss now where to go next. Should I just suck it up and continue to use the 4.1.06?
In Topic: N+ Serial Read Frequency
11 May 2011 - 06:24 PM
Good Afternoon and thanks for the info, some things to think about.
@Nevyn - I have the Stopwatch class in right now for a different application but I will look at using it for data collection/formatting. Makes sense.
@Tecchie - The Write line is there to output over a serial RS232 chip so I can read the data on a laptop or other computer real time, or near enough. As for the other line I found that without looking for the $ the code would always crash, I guess the better question for this line of code is why is it crashing without this line.
Thanks again I will post results soon.......
In Topic: Elapsed time
07 April 2011 - 10:50 AM
I got it to work with the Stopwatch Class. Thanks!
In Topic: Strange Data on SDA/SCL
05 April 2011 - 12:01 PM
is it possible that there is an issue with the clock? If the timing is off will that affect the way the I2C is read and data distributed/calculated? Is there a way to test the internal clock?
In Topic: Strange Data on SDA/SCL
01 April 2011 - 01:44 PM
Also here is a screenshot of a reading not sure if that helps either......
screenshot.png 10.37KB
22 downloads
- Netduino Forums
- → Viewing Profile: Posts: nturpin77
- Privacy Policy