Chuckles

I was looking at this

http://www.makershed...t_p/mkmts01.htm

Thinking that it might be valuable to have a Netduino Plus 2 attached and powered by it, and have that plugged into my AC outlet (I am in USA), so if the power goes out for any period my Netduino will keep running.

All comments appreciated.

Thanks.

What would be the benefit/drawback of connecting two Netduino units directly for communication? I have no real application in mind, just thinking that there might be a use to say have a 'mini detect a certain condition and then push a signal to a Plus 2. Just a random thought. All comments appreciated.

Thanksk.

Can anyone recommend a piezo buzzer/speaker part from any supplier (Adafruit, Sparkfun, Amazon, etc) that works well with the Netduino Plus 2?

Thanks.

Hey All. I have a Netduino Plus 2 with a Sparkfun photocell sensor wired up to Analog1 with a 10k resistor in the mix (equivalent to what you see in http://bildr.org/201...sistor-arduino/).

In my program.cs, I can drop a breakpoint at the event that is fired when the interrupt occurs, and after the first time the sensor interrupt occurs, the event is fired "forever", it does not ever stop.

After the event fires, I am logging the datetime ticks that the event happened, but then I do not want the event to fire again.

What is the proper programming pattern to accept the interrupt/event one time?

Thanks.