I2C is an open drain bus,the votage on the bus is decided by the pull up resistor,both pin for SCL/SDA on ND2+ is 5V tolerant.
You can connect it to any i2c device with pull up voltage equal or lower than 5V.
- Thomas Rankin likes this
![]() |
  | |||||||||||||
![]() |
|
![]() |
||||||||||||
Bi QinMember Since 17 May 2013Offline Last Active Sep 09 2013 12:37 PM | ||||||||||||||
![]() |
||||||||||||||
![]() |
|
![]() |
||||||||||||
![]() |
This webpage is licensed under a Creative Commons Attribution-ShareAlike License. | ![]() |
||||||||||||
![]() |