I am using the multplexer chip cd4067 and was wondering whether it is possible to chnage the direction of a pin from an output to an input.
#1
Posted 17 April 2013 - 03:28 PM
tony
#2
Posted 17 April 2013 - 04:24 PM
I am using the multplexer chip cd4067 and was wondering whether it is possible to chnage the direction of a pin from an output to an input.
Change the direction on the multiplexer or on the Netduino?
Regards,
Mark
To be or not to be = 0xFF
Blogging about Netduino, .NET, STM8S and STM32 and generally waffling on about life
Follow @nevynuk on Twitter
#3
Posted 18 April 2013 - 12:10 AM
Chnage direction from netduino...want some ports on 4067 to act as inputs and others act as outputs. But signal line can only connect to one pin on the netduino.
tony
#4
Posted 18 April 2013 - 06:21 AM
Chnage direction from netduino...want some ports on 4067 to act as inputs and others act as outputs. But signal line can only connect to one pin on the netduino.
Try defining a port as a TriStatePort.
Regards,
Mark
To be or not to be = 0xFF
Blogging about Netduino, .NET, STM8S and STM32 and generally waffling on about life
Follow @nevynuk on Twitter
#5
Posted 18 April 2013 - 12:43 PM
thanks Mark
tony
Also tagged with one or more of these keywords: cd4067, port
General →
General Discussion →
NetMF Port for the Adafruit Motor/Stepper/Servo Shield (V1)Started by mlsomers, 24 Jan 2016 port, shield |
|
|||
Hardware →
Netduino Plus 2 (and Netduino Plus 1) →
2nd Network Card for Netduino Plus 2?Started by cirving, 03 Jun 2013 Ethernet, Port, Shield and 1 more... |
|
|||
Hardware →
Netduino 2 (and Netduino 1) →
convert byte to stringStarted by mwesigebrian, 30 Apr 2013 byte, string, serial, port |
|
|||
Hardware →
Netduino Plus 2 (and Netduino Plus 1) →
Reset ethernet portStarted by RonZon, 02 Jan 2013 reset, ethernet, port, no, act and 1 more... |
|
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users