Hello all,
I have been looking into previous post about the step by step procedure to load a custom Netduino PCB. The idea is to have a consistent and clear instructions to load a custom PCB, derived from Netduino schematics, with appropriate bootloader and necessary framework to make c# run over. These two post talk about the subject but I can't find a final answer containing a complete walk-through, if there is one on existence, it would be nice to have it pointed out.
Previous Post:
http://forums.netdui...hl=+pcb +custom
http://forums.netdui...hl=+pcb +custom
How about adding an example of doing this to the Wiki?
