I would highly appreciate any thoughts on the following issue because I am desperate at the moment.
Everything worked superb until debug session with Mini was terminated unexpectedly. Since then I am unable to communicate with the device.
VS deploy now shows me the following
MFDeploy shows the following
And Putty shows the following when booting Mini
ESC does not work, any keys either.
It does succesfully boot into TinyBooter when DTR set to +5V but that does not change anything - still stops on "waiting for debug commands" without any reaction to the input. What does it waiting for?
FTDI cable should be working - I am able to see what I print in Putty when shorting Tx and Rx.
My settings are default - 115200/8/1/No/No.
Connection is default - VCC(21), GND(4), TX(11), RX(12) via FTDI cable (3.3V I/O TTL, 5V VCC).
I do not have USB-RS232 cable to flash new firmware but willing to get one if this will be the only choice.
It was all very fun until now
Thank you for any suggestions.