Javascript Disabled Detected

You currently have javascript disabled. Several functions may not work. Please re-enable javascript to access full functionality.

The Netduino forums have been replaced by new forums at community.wildernesslabs.co. This site has been preserved for archival purposes only and the ability to make new accounts or posts has been turned off.

Netduino as I2C slave?

Started by skyjumper, Jul 01 2012 02:14 AM

Please log in to reply

1 reply to this topic

#1 skyjumper

Member

Members
15 posts

Posted 01 July 2012 - 02:14 AM

Hi All... I was reading the data sheet for the uC used on the Netduino and I saw that it has 1 I2C port, and the data sheet says it is master only. Does that mean that it is not possible to use a Netduino as an I2C slave device? If it is possible, how is it done? Thanks...

#2 skyjumper

Member

Members
15 posts

Posted 01 July 2012 - 03:23 AM

Never mind, someone showed me the post that said it can not be an I2C slave, and can only be an SPI slave with difficulty. http://forums.netdui...3145#entry13145